Login    Register
User Information
Username:
Password:
We are a free and open
community, all are welcome.
Click here to Register
Sponsored
Who is online

In total there are 79 users online :: 5 registered, 0 hidden and 74 guests


Most users ever online was 155 on Mon Aug 15, 2016 1:40 am

Registered users: Bing [Bot], Google [Bot], Google Adsense [Bot], MSNbot Media, Yahoo [Bot] based on users active over the past 5 minutes

The Team
Administrators
Global Moderators
global_moderators.png CS

Sleeving issue

Post questions and info about pneumatic (compressed gas) powered cannons here. This includes discussion about valves, pipe types, compressors, alternate gas setups, and anything else relevant.
Sponsored 
  • Author
    Message

Sleeving issue

Unread postAuthor: DinerKid » Wed Jul 15, 2009 1:21 pm

hi i have a slight sleeving issue.

i currently have a 3/4" conduit barrel on my paintball cannon. i am noticing that about 20% of the shots curve a ton and i am guessing it is caused by the shot spinning due to contact with only one side of the barrel. i was told that i could sleeve pretty easily a piece of .5" sdr 13.5 into the current barrel to snug it up a bit on the paint ball. after looking for this in a hardware store (Home depot) i found nothing. then i looked online and found some specs and it appears that the OD of the .5" sdr 13.5 is about .84" while i measured with a caliper the ID of my conduit barrel to be .81". however when i looked up the spec it came out to be an ID of .86". so i am now left with two questions

1- can .5" sdr 13.5 be sleeved into .75" conduit with no or minimal sanding?

2- were is the best place to find .5" sdr 13.5?
  • 0


DinerKid
Corporal
Corporal
 
Posts: 67
Joined: Fri Aug 29, 2008 6:21 pm
Reputation: 0

Return to Pneumatic Cannon Discussion

Who is online

Registered users: Bing [Bot], Google [Bot], Google Adsense [Bot], MSNbot Media, Yahoo [Bot]

Reputation System ©'