Login    Register
User Information
Username:
Password:
We are a free and open
community, all are welcome.
Click here to Register
Sponsored
Who is online

In total there are 78 users online :: 4 registered, 0 hidden and 74 guests


Most users ever online was 155 on Mon Aug 15, 2016 1:40 am

Registered users: Alexa [Bot], Bing [Bot], Google [Bot], Yahoo [Bot] based on users active over the past 5 minutes

The Team
Administrators
Global Moderators
global_moderators.png CS

Breech Slider

Post questions and info about pneumatic (compressed gas) powered cannons here. This includes discussion about valves, pipe types, compressors, alternate gas setups, and anything else relevant.
Sponsored 
  • Author
    Message

Unread postAuthor: Panzerfaust » Mon Jul 02, 2007 12:37 pm

I just discovered something usfull in lowes today, go there and look for a "compression repair fitting" in your pipe size. they are small pieces of pipe with adjustabe piecies of rubber on either end contained inside screw caps. Standard pipe fits through the fitting making an airtight seal with the rubber ends. Leave it not tightened fully and u can slide it back and forth to close over your breach hole. If you absolutly need airtight then tighten it after you slide it into place, but i think it would be airtight even when it is loose enough to move.
  • 0

User avatar
Panzerfaust
Staff Sergeant
Staff Sergeant
 
Posts: 129
Joined: Tue Apr 17, 2007 4:37 pm
Reputation: 0

Unread postAuthor: SpoonZ » Wed Jul 04, 2007 4:15 am

I found myself a perfect seal by using electrical insulation. Called heat shrink. Comes in different sizes. You apply heat and it shrinks. so i slipped some over my pipe and it seals it 100%.
  • 0


SpoonZ
Corporal
Corporal
 
Posts: 64
Joined: Thu May 10, 2007 1:15 am
Reputation: 0

Previous

Return to Pneumatic Cannon Discussion

Who is online

Registered users: Alexa [Bot], Bing [Bot], Google [Bot], Yahoo [Bot]

Reputation System ©'