Page 1 of 1
My Copper Carbine
Posted: Sun Jan 01, 2006 8:20 pm
by Urban Ninja
This is my copper pneumatic cannon. It has a 22mm chamber and a 15mm barrel. It was so powerful, but unfortunately had to leave it in england when I moved here to australia where the laws are a lot stricter. Ill try to find some damage pictures on my laptop but everything is scattered everywhere on there so it may take some time.
Posted: Mon Jan 02, 2006 3:42 am
by Copperboy
Nice gun! like the design and stock/chamber.
Does it have a ballvalve, or is it for safety or pilot?
Posted: Mon Jan 02, 2006 4:02 am
by Urban Ninja
Thanks. The valve you can see on the barrel is a ball valve. I really needed to put a safety valve or pilot as it did jam occasionally and it was a huge effort to unjam it without the barrel shooting off!
Posted: Mon Jan 02, 2006 5:54 am
by Cronic
I like it, it's nice and simple. call me blind but I just can't see that ball valve...
Posted: Mon Jan 02, 2006 12:31 pm
by spudshot
the scope will move around and wont hold a zero, you could possibly buy some weaver mounts and scope rings and permanantly attatch it somehow ( i think they allow some guns in australia, so weaver mounts shouldnt be hard to find)
Posted: Mon Jan 02, 2006 4:57 pm
by beebs111
he said he left it in england when he moved didnt he? thats a shame never leave a man behind
Posted: Mon Jan 02, 2006 6:33 pm
by Cronic
Oh I see the valve now... Too bad you had to leave it.
Posted: Mon Jan 02, 2006 9:45 pm
by Urban Ninja
Dont worry it didnt go to waste, I gave it to a friend that will get a lot of good use out of it. Thanks for your advice spudshot Ill keep my eyes open for those!