Page 1 of 1

semiminimidsized coax

Posted: Tue Mar 04, 2008 10:43 pm
by elitesniper
Well i didnt know if this was a mini or a normal coax, o well i just posted here, will this is my lasted project, specs are , 3/4 sch 80 chamber, .177 cal pellet barrel,1/4 exhaust,piston is soild rubber cut to size, pressures use right now are 145 psi but the power is pretty good for a spuddy of this size :lol: hope you guys like it.

Posted: Tue Mar 04, 2008 11:04 pm
by Carlman
nice work there mate, seems to work good aswell :D

Not the cleanest looking gun but if it works it works :wink:

Posted: Tue Mar 04, 2008 11:35 pm
by jackssmirkingrevenge
Up the pressure, you'll know the difference :) you'll need a schrader though if you're using a shock pump.

also, the yellow pages test is normally done from the front, not the side ;p

Posted: Tue Mar 04, 2008 11:42 pm
by elitesniper
haha the side was to show the penatration :) if i use a shock pump im guna make an adaptor for the QC its guna be the female QC to barbed adaptor to tubeing to female barbed to homemade male threaded shrader, sound good?

Posted: Tue Mar 04, 2008 11:46 pm
by jackssmirkingrevenge
elitesniper wrote:The side was to show the penetration :)
Ah, but that's cheating - it's easier to for the projectile to spread the pages aside fron an end of the book than it is to penetrate them head on, so it gives the illusion of deeper penetration.

As to your filling arrangement, sounds like a plan :) and word of warning, at high pressure and with such a large C:B ratio, it will be loud...

Posted: Tue Mar 04, 2008 11:49 pm
by elitesniper
hehe mabey i was cheating just a wee bit hehe, as for loudness ive think ive gotten used to it since i always fired my 2'' piston with n barrel :) mabey i should get new ears for my birthday.

Posted: Tue Mar 04, 2008 11:51 pm
by jackssmirkingrevenge
elitesniper wrote:Maybe I should get new ears for my birthday.
... that or epoxy a male threaded fitting to the barrel and make your own mini-silencer ;)

Posted: Tue Mar 04, 2008 11:56 pm
by elitesniper
haha, good idea, coming from the master o epoxy, or i can add a highlighter with holes drilled on side with cotton on the inside, highlighter for authenticity :)

Posted: Wed Mar 05, 2008 12:30 am
by ghostman01
yeah well thats what i did for my .177 bb gun, i made a silencer for that and it reducess the sound by 2 db lol not much but its all made from textas

Posted: Wed Mar 05, 2008 7:40 am
by Mitchza89
Ah so this is the little gun you were talking about :P she looks tops mate. Very well done on this little ripper!

Posted: Wed Mar 05, 2008 8:41 am
by bigbob12345
Very nice mini coax similar to mine except mine is copper.
and what did you use to attach the barrel?

Posted: Wed Mar 05, 2008 6:46 pm
by elitesniper
thanks guys um i just drilled a hole in a 3/4 endcap and put the barrel in with some epoxy around the gaps :)