Page 2 of 2

Posted: Sun Jul 20, 2008 3:50 pm
by SpudFarm
hmm i missed this - strange :O

extremely cool gun! i like small guns.

Posted: Sun Jul 20, 2008 4:39 pm
by Kobl
Thanks everyone, but this mofo is out of commission until I get my piston sorted out. I really need some real epoxy resin.

Posted: Sun Jul 20, 2008 9:18 pm
by blind909
Try MCmaster.com.

Posted: Sun Jul 20, 2008 10:30 pm
by dungdue0
you should put a co2 and some type of hopper/magazine and use it in airsoft matches

Posted: Mon Jul 21, 2008 10:41 am
by Kobl
I plan to make a Brian the Brain blow forward breach and convert it to full auto as well as get a c02 remote coil setup.

Also, I'm looking around on McMaster right now and can't find anything that seems suitable/that is in my price range, so if anyone could give me a product number that would be helpful.

Posted: Tue Jul 22, 2008 1:28 pm
by blind909
7605A13, Or 6615A11

Posted: Tue Jul 22, 2008 1:52 pm
by Kobl
I don't think you understand you understand epoxy casting :/

Both those are either solid or pastes, I've happened to used both of those types of epoxies.

I need a low viscosity(watery) pourable epoxy.

Posted: Tue Jul 22, 2008 1:55 pm
by blind909

Posted: Tue Jul 22, 2008 1:57 pm
by blind909
Found what you were lookin for, pourable, low viscosity, castable, and low toxisity.

http://www.eagerplastics.com/5340.htm


Or this


http://esticker-simply-fun.amazonwebsto ... ce=froogle

Posted: Tue Jul 22, 2008 2:01 pm
by Kobl
The minimum order of that stuff is two and a half pounds...

The website seems a bit sketchy too. I'm trying out a hot-glue piton again and if that doesn't work I'm just gonna try to find a local epoxy resin seller.

Posted: Tue Jul 22, 2008 2:04 pm
by blind909
I have used hot glue pistons before, and in this Las Vegas Heat(118-126 degrees), they melt and fu@k up your gun.

Posted: Tue Jul 22, 2008 2:33 pm
by Wombat
Try mixing the epoxy VERY thoroughly, and make sure that the proportions are correct. I used to think that every epoxy I had was just a bad batch, or a bad brand. I was really just not mixing it well enough, or mixing it in the wrong proportions.

Posted: Sun Jul 27, 2008 10:54 am
by Kobl
Expect an update sometime today or tomorrow, I'm raiding Homey D's today for parts.

Edit: Well as it turns out all of my sources for cannon parts are sucking dick lately, I can't find anyfuckingthing I need. No updates for a while, not until I can get a parts list together for McMaster.

Edit edit: This gun is now going to become an auto piston, check out the build log in the discussion section.