Page 1 of 1

first piston valve sniper

Unread postPosted: Sat May 09, 2009 7:41 am
Author: Crna Legija
hi all this is my first piston valve gun i have made. it is a 3/4inch tee with a 3/4inch connector wich holds my hot glue piston in it i have a bit of neoprene from my mouse pad held on my glue and a bolt.my chamber is a fire extinguisher coverd in black duck tape i tryed to pant it put is failed.im geting my bro to make a 3/4 inch dia stainless steel chamber about 40cm long at his work he can put threds on won end and a cap on the other and weld it up the guy at his work sed it hold up to 1000 psi put i run it at like 200 max i need a better shock pump my wons for a dirt bike.
my barrel is a 80cm 8mm realy thick walled stainless steel i got form my dads work sleved in a 1/2inch pvc pipe.i made a ghetto breach load for now ill make a better won later.im going to make a stock when i get my new chamber ill try to make it look like a awp from counter strike . and ill give my hand at a bi-pod

without further ado my sniper


how do i make a preview pic?

Unread postPosted: Sat May 09, 2009 8:37 am
Author: Mitchza89
By no means the prettiest gun but I love the layout and the streamline look.

Very good job on it mate :) More damage pics!

Unread postPosted: Sat May 09, 2009 12:51 pm
Author: far_cry
nice air gun bro
i see that all the parts you found are used good way to save money :D

air chamber is to to to much big
and the 3/4" new chamber you want to make make it 15cm if you work at 200 psi . and if you about to make pump to get 600 psi so make it 10 cm long because your barrel is small diameter and short . just like my barrel but mine is 95 cm long

Unread postPosted: Mon May 11, 2009 8:25 am
Author: Crna Legija
thanks for the nice comments.

Mitchza89
By no means the prettiest gun but I love the layout and the streamline look.

Very good job on it mate More damage pics!
yer ill make it look nicer later but for now it puts holes threw 55gallon barrels and il got some stuff to shoot ill have a vid of a ps1 getting shot soon wihile its on

nice air gun bro
i see that all the parts you found are used good way to save money

far_cry
air chamber is to to to much big
and the 3/4" new chamber you want to make make it 15cm if you work at 200 psi . and if you about to make pump to get 600 psi so make it 10 cm long because your barrel is small diameter and short . just like my barrel but mine is 95 cm long

i got him to get a bit bigger chamber coz i have a mabel barrel and a 3/4 inch 1 [/quote]