Yup, was confused when you said gate valve and flap check valve cause they work differently
This solves my problem on my piston gun, too bad i made a rash decision to disassemble and exchange my parts
Just a question, i tested this spud WITHOUT a chamber, briefly pumping it up and using that small little handle with a 1/4" diameter and 4" length as a mini testing chamber before i get my hands on an aluminium bottle.
It only managed to shoot my cone-dart projectile to the end of the barrel and hang out of the muzzle. Does this mean even if i have my proper chamber it will still be so weak? Or is it just cause there isn't much pressure and the chamber is so puny, and whats more, it leaks a little
Blowgun Spud with Reload Mechanism!
- inonickname
- First Sergeant 4
- Posts: 2606
- Joined: Sun Dec 07, 2008 3:27 am
The gas expands a lot, so your loosing a lot there. Bigger chamber = moar. Moar = good.
A gate check valve and flap check valve are the same thing, as they swing open (like a gate). However, a gate valve does not swing open, rather it travels vertically up and down. (god damn, where does the bit disappear to?)
A gate check valve and flap check valve are the same thing, as they swing open (like a gate). However, a gate valve does not swing open, rather it travels vertically up and down. (god damn, where does the bit disappear to?)
PimpAssasinG wrote:no im strong but you are a fat gay mother sucker that gets raped by black man for fun
What did you mean by the gas expanding and me losing alot?
Should i go for an aluminium bottle like this?
According to GGDT, using a bottle as compared to the 12" and 18" 22mm pipe gives much better performance. I know people have used these aluminium sport bottles before and i need a confirmation on the pressures these things hold?
Should i go for an aluminium bottle like this?
According to GGDT, using a bottle as compared to the 12" and 18" 22mm pipe gives much better performance. I know people have used these aluminium sport bottles before and i need a confirmation on the pressures these things hold?
- inonickname
- First Sergeant 4
- Posts: 2606
- Joined: Sun Dec 07, 2008 3:27 am
They're quite common on french spudguns, you'll find they'll take 100-up to 150 if you're game..
What I meant, is that the gas expands so much pressure is basically non-existant. Solution: MOAR
What I meant, is that the gas expands so much pressure is basically non-existant. Solution: MOAR
PimpAssasinG wrote:no im strong but you are a fat gay mother sucker that gets raped by black man for fun
- Major Collins
- Specialist 2
- Posts: 264
- Joined: Wed Nov 18, 2009 6:18 am
- Location: Western Australia
omg i use this design lol and and my barrel is 19 mm and the tee is like 20 and a very good fit and i use marbles cos the are around 16 to 18 mm ish but i dont particularly like this design of pulling out the and in the barrel continuously so yeah:/ buy make it into a hopper it wont need to take magazines then and be more like a paintball gun : ) instead i use the top of the tee to put a like circle shower fitting and its my top site
quick pic
quick pic