Page 3 of 3

Posted: Mon Sep 07, 2009 9:02 am
by jmadden91
Looks gorgeous mate very well done

Posted: Mon Sep 07, 2009 11:25 am
by wngovr
I bet that stock was a lot of work. Looks good.
I like the look of the copper tie downs too.

Posted: Mon Sep 07, 2009 5:48 pm
by absinthe
wngovr wrote:I bet that stock was a lot of work. Looks good.
I like the look of the copper tie downs too.
you could say that but i enjoyed makeing it.. and i think it will look good with some dark stain and varnish

Posted: Mon Sep 07, 2009 6:50 pm
by JDP12
Wow that stock is amazing! Sick job man

Posted: Tue Sep 08, 2009 3:44 am
by absinthe
thanks :) but its still not finished yet :P

Posted: Sat Sep 12, 2009 7:20 am
by absinthe
just some damage pics

@500psi number 0 sinker at about 6 mtrs into 12mm marine ply and 2 sheets of thin steel, went trough the ply and one sheet of steel almost through the next
Image
Image
Image
Image
Image
i have had some problems with my sealing face (and the backing washer) i have tried a new sealing face and a steel washer as the piston fling back bent the washer slightly concave after awhile :P