Page 2 of 2

Posted: Wed Sep 09, 2009 9:03 pm
by THUNDERLORD
I Like the design very much Mitchza!!!
Maybe a solenoid hammer could be added at some point for semi/full auto action.
OR a spring plunger could be used inside the chamber that presses the triggering bolt once proper pressure is reached for completely mechanical action.
A sleeve blocking the magazine could be attached to either as the trigger bolt is moved rearward (sleeve attached could move with it).

I was wondering what QEV that is?
Looks sleek. Like always, nice work there Mitch! 8)

Posted: Wed Sep 09, 2009 9:05 pm
by twizi
looks good i think this will vent my 1/4 good

Posted: Thu Sep 10, 2009 12:37 am
by Mitchza89
Thanks a lot Thunderman. I'm sure I'll come up with something that works well.

Twizi, I have no doubt that this trigger will work perfectly in your application.

Posted: Fri Sep 11, 2009 8:42 am
by absinthe
i just received some QEV's like yours from bellpro.. and was very disappointed :( i haven't tried em yet but the port holes are tiny (1/2" threads but the center hole is about 1/4" although i think it could be opened up somewhat) and they also sent me one that has no thread on the output!!! but i will be trying this type o valve on one soon

Posted: Fri Sep 11, 2009 8:18 pm
by Mitchza89
I'm afraid the majority of QEV's are like that. The output is a fraction smaller than what would be 1/2'' copper tubing. The no thread on the output is a big problem though. By all means send it back and complain. Nothing will beat a well made piston valve but as far as convenience goes and functionality goes, QEV's are very good.

Posted: Sat Sep 12, 2009 9:28 pm
by maverik94
It could easily be converted into a hammer valve for a pcp gun.

Posted: Sun Sep 13, 2009 1:05 am
by Mitchza89
Absolutely mate. That's the idea. Thanks very much for the post :D

Mitch.