Page 1 of 1
.68 call pistol bike pump powered
Posted: Sun Apr 28, 2019 5:27 am
by Surfer_wlan
So I wanted something small to shoot paintball size projectiles and to be manualy powered. I used T piece brass piston valve (common design), shortened shrader valve for trigger, and smallest bike pump i could find for power source. The rest are brass fittings, teflon tape, epoxy glue and PP pipe for barrel. Need to improve tightness and smoothness oof piston operation and will be able to shoot some 15 yards relatively straight with about 3bar pressure.
Re: .68 call pistol bike pump powered
Posted: Sun Apr 28, 2019 5:53 am
by jackssmirkingrevenge
Welcome to the forum and nice work! I like the way you configured the pilot valve to act directly as a trigger, quite a neat setup.
Re: .68 call pistol bike pump powered
Posted: Sun Apr 28, 2019 12:58 pm
by keks2033
Try to connect instead of the pump cylinder with Greengas. This can be done even with cold welding and electrical tape.
Re: .68 call pistol bike pump powered
Posted: Wed May 08, 2019 5:19 am
by Mike Vity
Hey, can you send more photos please?