Page 2 of 2

Posted: Tue Jul 10, 2007 3:49 pm
by rednecktatertosser
LOL!! i got it for 3 dollars on amazon.com. i look forward to seeing your qev sniper.

Update on testing- I got my bike pump to work, i have to pump very slowly and carefully i got it up to about 70 psi, but the equalization hole is very small and it equalizes very slowly, which i didnt realize untill i shot it and only got a 12g CO2 cartridge about 3 feet.

@salty- dont worry ittl look like the general lee before too much longer.

Posted: Tue Jul 10, 2007 5:42 pm
by Modderxtrordanare
I got mine for $.01 cents on amazon, I used my gift card on it too so it was free. Because my bank is stupid and gave me 200 dollars and so did amazon, when I was only owed 200. I got 400 collectively, so I bought 200 dollars of stuff on amazon and kept the 200 my bank gave me for gas.

Posted: Tue Jul 10, 2007 9:45 pm
by rednecktatertosser
That reminds me, you owe me that pirate flag.

Posted: Wed Jul 11, 2007 8:29 am
by spud yeti
Well, i found my bike pump, but it started tarding out, and wont pump past about 20 psi, plus my parental units are too cheap to buy me an air compressor. so i have to wait till my neighbor is back to borrow his.
Snap, my "parental units" wont either :cry:
That pirate flag sounds freaken awesome, wana post a pic?
Why dont you increase the size of your equalisation hole to increase speed?

Posted: Thu Jul 12, 2007 6:01 pm
by rednecktatertosser
Well the propblem with the equilization hole is that i drilled it to close to the center and it is closed off by the rubber seal and pressure from being shoved against the barrel. so right now im really wishing i had made a serviceable piston. :(

Posted: Tue Jul 17, 2007 1:28 pm
by spud yeti
Oh yeah, you cemented it in, didnt you. That kinda sucks. I guess you can only learn for next time... so start building! Haha, no, what are you going to do, cut it up to change the piston or just leave it?

Posted: Tue Jul 17, 2007 2:05 pm
by rednecktatertosser
im gonna try drilling a better hole throught the detachable pilot/fill setup first then if all else fails, ill cut it like an emo. :D