SpudFiles

I wanted a fan mount that would let the fan swing out of the way for breech loading without hanging from the wires. I cut a 3/4" piece of 4", the same as the chamber. Cut a fan size section out of it. Drilled the ends of the C slightly larger than a coathanger. Here I used two saftey pins and a piece of CH wire for the hinge because I couldn't find cotter pins in the garage. Squeeze the C and slide it in, it stays right where you put it.

Very ingenious, nice touch

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.

that's a brilliant solution, well done! definately going to start building a coax soon using this

cool wish i had thought of that .