Page 2 of 2

Posted: Wed May 24, 2006 5:30 am
by FiveseveN
1. Try some teflon tape on that thread (you ARE using a threaded cap, aren't you?).
2. If you fasten it with screws like in the picture above, it should stay put.
It also has less surface against the flame front, so it gets pushed with less force than your cap.

Posted: Fri May 26, 2006 12:16 am
by dopey
nah i am using a push cap with 4 heavy duty screws last time it took out chunks of pvc pipe at me

Posted: Fri May 26, 2006 11:49 pm
by ProfessorAmadeus
you should be using a treaded one so that doesnt happen again. i've got one question about the fan. How do you power it? with 9 volt batterys? If so how many?

Posted: Sun May 28, 2006 5:27 am
by dopey
mabe i am use one of my fans out of my old cpu and using a 9 volt battery and it seems to works alright cuz now i can shoot my spud gun more quicker now

Posted: Sun Jun 11, 2006 1:05 pm
by plumpthumb
Just anote on the efficacyof the fan. I installed one in my propane cannon and
such a difference in performance (including the noise-but that's okay). It sent that cannon from a good performer to a real kicking mule! I also installed a
spark strip which gives me a great ignition. Worth the upgrades.

Posted: Sun Aug 13, 2006 12:48 am
by Jarim
question.... how do you spray your fuel into the gun if the fan is in the way... do you spray into the fan? or what... and how is the fan held in place... and another ? is it worth it for what you pay?. .. anyone who has one installed

Posted: Thu Sep 21, 2006 3:59 pm
by sv490665
My chamber fan is friction mounted, and it never comes out or moves around. By the way one of you asked which direction should it be blowing? the answer- it should be blowing fresh air into your chamber
==========-- _________________
air---FAN---> ]_________________|
==========-- BARREL
CHAMBER

One question i have though, is why my chamber fan burned if i have propane injection? it's not working, it used to, my wiring, battery power, on/off switch and electrode connectivity is all good i tested it with another fan. Is there anything like a covering for the middle part of the fan that i could glue on to protect it? It looks like my cannon burned a hole through the middle where the sticker was and right into the little silicon chip.

Posted: Thu Sep 21, 2006 4:00 pm
by sv490665
My chamber fan is friction mounted, and it never comes out or moves around. By the way one of you asked which direction should it be blowing? the answer- it should be blowing fresh air into your chamber
==========-- _________________
air---FAN---> ]_________________|
==========-- BARREL
CHAMBER

One question i have though, is why my chamber fan burned if i have propane injection? it's not working, it used to, my wiring, battery power, on/off switch and electrode connectivity is all good i tested it with another fan. Is there anything like a covering for the middle part of the fan that i could glue on to protect it? It looks like my cannon burned a hole through the middle where the sticker was and right into the little silicon chip.