Page 1 of 1

Milkcap wadding/burst disk (Yoplat Smothie)

Posted: Sat Jul 07, 2007 5:17 pm
by Hailfire753
Hey guys, quick question. I just found a great wadding for people with 1.5'' barrels. It is the cap on those small smothie bottles. We just got a pack of 20, and they fit almost perfectly in the barrel. However, the bottom of the cap is slightly flared, so that it slides smothly in up to that point. It is posibile to jam it in the barrel(with a screwdriver lol), but it is super tight.

Do you think this causes any danger to the gun (combustion)? If the cap doesn't budge, will it act like a burst disk? The plastic is about as thick as a regular screw-on milkcap.

Or should I sand off the flared part?

Posted: Sat Jul 07, 2007 5:25 pm
by Fnord
It will move. Trust me.

Posted: Sat Jul 07, 2007 5:29 pm
by Hailfire753
Thats what I thought, but I needed an opinion. thx for comment.

Posted: Sun Jul 08, 2007 2:01 am
by SpudBlaster15
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.