Page 3 of 3
Posted: Tue Jan 26, 2010 9:07 pm
by twizi
guy im thinkin about somthin like this [url]
http://airgunartisans.com/AAHomemade2.htm[url] one right above pitbull
but in a 50 cal or a 45 cal
any ideas or i have the materials to do it but just wondering if youve done anything like it
Posted: Tue Jan 26, 2010 9:11 pm
by maverik94
Posted: Tue Jan 26, 2010 10:06 pm
by inonickname
Aluminum, brass and steel, with a HPA reservoir.
Do you have a machine shop to do this with twizi? It's no mean feat..do you also have the facilities to rifle the barrel?
Posted: Wed Jan 27, 2010 6:01 am
by psycix
Re-URL-ed
http://airgunartisans.com/images/HomeMa ... %20007.jpg
Unless you have a machine shop, all you can do is
think about it.
Posted: Wed Jan 27, 2010 5:18 pm
by twizi
i have acess i just need to get my design finalized i have a lathe a mill and a cnc water ject at my dads company.
Posted: Tue Feb 16, 2010 12:10 am
by Patto
Ok please be nice if i am wrong..
but couldn't you just make a valve like the hammer valve in Gippeto's co-ax ??
could you get a piece of solid ally drill your center hole 3mm and then drill your port in the side. place 2 o'rings either end of the solid and a grub screw hole in the middle between the orings then slide the valve down into your chamber and grub screw it in place. (ruff version)
then all you need is a snug fit pipe/tube to go between your valve and breach ?
the hardess part i think would be the seal , all real pcp guns use (sorry to all but most) delrin plastic as there seal. i think this could be possible
here are some excamples, from real pcp guns
