what im talking about is something like this. there are a lot of thunderstorms where i live and because of that the power goes out frequently. well im wondering if what im about to describe even exists. but basically what the device does is keeps the electricity flowing to whatever i have hooked up to it and if the power goes out then the device would shutoff or reset or something so that when the power comes back on the device wouldn't supply power to whatever was plugged into it until i reset it or something similar.
does that make sense?
im not sure what this is called but heres my description.
Marvin the Martian: Where's the kaboom? There was supposed to be an earth-shattering kaboom!
Marvin the Martian: The Earth? Oh, the Earth will be gone in just a few seconds.
Marvin the Martian: The Earth? Oh, the Earth will be gone in just a few seconds.
PCGUY wrote:Congrats, your the first donating member I have had to ban.
Are you referring to a UPS or a backup generator?
http://en.wikipedia.org/wiki/Uninterrup ... wer_supply
http://en.wikipedia.org/wiki/Uninterrup ... wer_supply
An RCD (residual current device) will usually do this as well as it's main function. when the power goes off it trips a switch which can only be turned back on manually.
Just run an electrical cable over the local hospital, they have back up generators... haha totally kidding.
"physics, gravity, and law enforcement are the only things that prevent me from operating at my full potential" - not sure, but i like the quote
you know you are not an engineer if you have to remind yourself "left loosy righty tighty"
you know you are not an engineer if you have to remind yourself "left loosy righty tighty"
- Technician1002
- Captain
- Posts: 5189
- Joined: Sat Apr 04, 2009 11:10 am
A simple relay and a push button switch is all that is needed. Pick up an electrical contactor (big relay) with a 120 volt AC coil. Hook the coil to the output of the relay. Use a pushbutton to connect the input to the output. Plug it in and push the button to turn it on. It will stay on until the power fails, then it will remain off until the button is pushed again.
Many motor contactor controls are configured that way to prevent injury from an unexpected machine start. It won't start until the button is pressed.
Many motor contactor controls are configured that way to prevent injury from an unexpected machine start. It won't start until the button is pressed.