I need to make a 34mm hole..
Posted: Wed Jul 14, 2010 6:33 am
I'm looking for a way to make a 34mm hole on my lathe. ATM my largest drill is 1". I could drill the initial hole with this and enlarge it with a boring bar but they will be a PITA for large production runs.
So basically, I'm looking for a way to bore a hole in a plastic such as HDPE around 110mm deep. I can make the bit or buy it. Preferably not spending too much. Perhaps a spade bit?
thanks
So basically, I'm looking for a way to bore a hole in a plastic such as HDPE around 110mm deep. I can make the bit or buy it. Preferably not spending too much. Perhaps a spade bit?
thanks