SpudFiles

I need some input, I would like to build a inline style rifle, with a all stainless steel barrel, and chamber, looking to run pressures of about 200psi, off regulated co2, i would like it to have an inline valve, for obvious trigger position, and ergonomic reasons, looking at either a 1/4 inch or 1/2 inch id barrel options, I have considered a co-axial have rough plans, and a fully mapped out gas supply via remote line and inline regulated co2 paint ball tank. However, and as I am a religious follower of JSR's minimal pilot volume, i have to forgo the ergonomic aspect or the minimal pilot volume.

Maybe you should look at my lattest cannon

http://www.spudfiles.com/forums/latest- ... 13845.html

Its not an inline(well you could say it is), and the valve is 25mm (1')... but the concept of it is ergonomic and minimises pilot volume. JSR even said so...

I hope that helps

Thanks man, what i am actually going for is a sniper type setup, would like to use a box type clip, I'll work on a image and up load it a.s.ap might help you guys understand my problem.