Page 3 of 3
Posted: Fri May 09, 2008 5:03 pm
by jrrdw
Dremel out the tee to the half way point, use a short piece of pipe for a cylinder the piston can ride in.
Posted: Sat May 10, 2008 6:15 am
by psycix
jrrdw wrote:Dremel out the tee to the half way point, use a short piece of pipe for a cylinder the piston can ride in.
Ride? Id rather call it slide
But yes, that can do it.
Posted: Sat May 10, 2008 5:47 pm
by no-limit
Dremeling out the tee sounds like a very long and diffcult time.
Posted: Sat May 10, 2008 5:57 pm
by MrCrowley
Edit: Sorry wrong topic.
Anyway, i've done it in 5minutes with a holesaw, they cost a bit, but it's worth it. You can get sets for about $20 now.
Posted: Sat May 10, 2008 6:10 pm
by jrrdw
no-limit wrote:Dremeling out the tee sounds like a very long and diffcult time.
It's harder to not go to deep then it is removing the plastic inside the tee.