Page 1 of 3

filling multiple chambers at the same time

Posted: Sun Jun 08, 2008 2:45 pm
by trollhameran
Im looking for ideas of a way to fill multiple chambers at the same time using a single compressor, the chambers will be 2 liter bottles and they cant be filled through the cap. Does anyone have an idea how to do this?

Posted: Sun Jun 08, 2008 3:04 pm
by MrCrowley
Image

Posted: Sun Jun 08, 2008 3:13 pm
by SpudFarm
or you can use multiple TEE hose barbs to make many hoses of one.

Posted: Sun Jun 08, 2008 3:18 pm
by trollhameran
Crowley what is that adapter called? so i can search it on google.

I had thought about using tees but i wanted to see if there was an easier way before i decided on using them or not.

Posted: Sun Jun 08, 2008 3:29 pm
by SpudFarm
ok what about a 1/4" NPT cross that you put one male adapter in and three female quick connects?
should be cheaper

(a huge amount of hard spelled words in that post)

Posted: Sun Jun 08, 2008 3:33 pm
by trollhameran
hmm thats a good idea spudfarm, would definately be cheaper than tees and would take up less place

Posted: Sun Jun 08, 2008 3:38 pm
by SpudFarm
yepp

Posted: Sun Jun 08, 2008 3:46 pm
by trollhameran
now just need to find somewhere to buy them in the UK.

While were on the subject, will epoxy glue 15mm pipe either copper or pcv in through the side or the bottom of a pet bottle and be able to hold pressure?

Posted: Sun Jun 08, 2008 3:51 pm
by SpudFarm
i would not bet on that if i could not get it on the inside

Posted: Sun Jun 08, 2008 3:53 pm
by trollhameran
If I could get the epoxy on the inside of the bottle could it work then?

Posted: Sun Jun 08, 2008 3:57 pm
by bigbob12345
Well the epoxy will stick fine to the copper or pvc but it wont stick very well to the bottle and will eighther leak or just blow off.

Posted: Sun Jun 08, 2008 4:00 pm
by trollhameran
Hmm thats kinda buggered me up then, know of anything that will stick to both and will hold pressure?

Posted: Sun Jun 08, 2008 4:04 pm
by SpudFarm
if you get a nice layer on the inside of the bottle around the pipe. it sticks to the pipe making it to big to go through the hole

Posted: Sun Jun 08, 2008 4:07 pm
by trollhameran
so if i did that and then stuck an o ring to the pipe on the outside of the bottle so it was tight against the bottle then it should hopefully work then

Posted: Sun Jun 08, 2008 6:10 pm
by psycix
Why use a bottle if you can also use PVC?
Its worth those few bucks.