Page 1 of 1

By request of Mitch, i am actually posting something.

Posted: Sat Feb 07, 2009 8:10 am
by Necrosis
The design and actual work done on my hammer valve pnaumatic.

Comments are appreciated, it will run off of 200 ish bar by the way, so hooraay for me, if I survive filling it up.

Posted: Sat Feb 07, 2009 8:16 am
by inonickname
Sweet. Never seen much of your work but that is awesome. Wish I had tools like what you have while working on my blowback.. (lathe..)

Posted: Sat Feb 07, 2009 9:42 am
by Brian the brain
Looks great, canĀ“t wait to see the endproduct!!

Posted: Sat Feb 07, 2009 9:50 am
by jrrdw
OK, I'll bite. Why doesn't "Mitch" post for himself?

Is the cannon you have this on currently, done?

Posted: Sat Feb 07, 2009 12:14 pm
by Ragnarok
jrrdw wrote:OK, I'll bite. Why doesn't "Mitch" post for himself?
I'll guess... Mitch asked Necrosis about Necrosis' project, and Necrosis posted the information that Mitch was asking for.

Posted: Sat Feb 07, 2009 1:25 pm
by Gippeto
Looking very good! :) Nice job on the threads too.

Why did you decide to place the spring externally?(Or is that not a spring retainer on the valve stem?)

Posted: Sat Feb 07, 2009 1:29 pm
by SEAKING9006
Very nice, I have always liked custom hammer valves. I have a design floating around my file drawer with a design for a 'reversed' hammer valve that is part of the bolt, rather than the breech.

Posted: Sun Feb 08, 2009 7:48 am
by psycix
Nice. Will this be used to pilot a gun?
Could do semi-auto if you used a modded QEV.

Posted: Mon Feb 09, 2009 4:57 am
by Necrosis
Gippeto wrote:Looking very good! :) Nice job on the threads too.

Why did you decide to place the spring externally?(Or is that not a spring retainer on the valve stem?)
It is a spring retainer, it will be adjustable using a threaded connection, so it also kind of acts as a regulator ish device.

This is just a test piece, stainless steel comming up today or tommorow. : )



psycix wrote:Nice. Will this be used to pilot a gun?
Could do semi-auto if you used a modded QEV.
Yes it'd be used to pilot a pilot gun for my railgun. *confuzzlewuzzle*

Posted: Mon Feb 09, 2009 6:42 am
by Sticky_Tape
I thought you were going to make a gun like the condor but oh no that wouldn't have high enough volocities for you!