Simple Question I Just Haven't Been Able To Get An Answer To
Posted: Thu Jun 25, 2009 8:59 am
by Foxx
Hey guys, I know this is a really basic/probably stupid question, but can someone here explain to me exactly what is a co-axial and how it works/how to make one? (Yes, I have searched, and no, I didn't find a satisfactory answer)
What "sets it apart" is that the barrel runs through the entire chamber.
Posted: Thu Jun 25, 2009 9:13 am
by Pilgor
Don't use a bell reducer
Posted: Thu Jun 25, 2009 9:26 am
by Technician1002
The actual definition of coaxial is two cylinders on the same axis. The chamber is outside the barrel. The most common configuration is a piston in the breech with the barrel inside the chamber to the piston at the breech. The term comes from the electronics industry where a cable has one conductor inside the other one.
A coaxial cable has an outer conductor on the same axis as the center conductor.
Posted: Thu Jun 25, 2009 10:18 am
by Carlman
Why do all the words in the title of this thread have a capital letter?
Looks like it needs an acronym... SQIJHBATGAAT.......
Posted: Thu Jun 25, 2009 10:50 am
by THUNDERLORD
Why do all the words in the title of this thread have a capital letter?
Looks like it needs an acronym... SQIJHBATGAAT.......
Actually there was a thread about a year ago on making better posts, and it instructed to use cap.s...It was a good usefull post, (Link? can't find it now???), About writing cannon specs, getting more views etc.
I always capitalize each word in a post since I read it. 8)
BTW, for pneumatics aren't co-axial the most efficient(???)
I just like them because of the "Bullpup" configuration I'm fond of.
Also been thinking about them because all the dang brass "T"'s I find are cast. Course I did see smaller diameter cast fittings on a helium tank recently.
Besides all the local brass nipple pipe only goes to 3/4" so my chamber would be too small. Guess I'll stick with my cast brass "T"...
EDIT:Found it I think Great posting info too.
I thought it was a sticky. Should be added to the "rules" IMO.
Where the heck is MrC.??? If I don't find out soon I will probably flip out!!!
PM me someone....
EDIT2: No that's not the exact thread (??? where???)...
8) 