Page 2 of 2

Unread postPosted: Mon Jun 29, 2009 10:36 am
Author: maggotman
the onlay problem with doing it to a fridg compressor is the orignal motor cant cope with the input pressure, and usaly stalls and its not realy safe.

Unread postPosted: Tue Jun 30, 2009 2:55 pm
Author: psycix
I opened one up (didnt I post pictures of that?) and the reed valve was in the flat plate on top of the cylinder. The flat piston head nearly touches the top plate within like a tenth of a mm.
Dead space is minimal.

Unread postPosted: Tue Jun 30, 2009 7:18 pm
Author: Technician1002
psycix wrote:I opened one up (didn't I post pictures of that?) and the reed valve was in the flat plate on top of the cylinder. The flat piston head nearly touches the top plate within like a tenth of a mm.
Dead space is minimal.


How thick is the flat plate and the volume of the space in the hole? What is the dead space of the valve?

Spell check works. :)

Unread postPosted: Wed Jul 01, 2009 5:16 am
Author: psycix
Image

Unread postPosted: Thu Jul 02, 2009 8:11 am
Author: maggotman
when mine stoped at 1800psi its was becuse of that paper gasket failing if i could titen down the bolts it probaly could have give more