New and Simple idea for breech loading?
Posted: Sat Sep 26, 2009 1:56 pm
I'm sorry if this has been posted before I'm not on too often here.
My idea is to use a hot glue gun to make a breech.
(1) So you get a sample of the barrel and you get a larger size pipe
(2) Fill in the space (Inside the larger pipe and outside the smaller barrel [The barrel size you'll be using]) with hot glue.
(3) Now you should now have a cylinder with a hole in it.
(4) Create a handle. I have seen other breeches created with a hose clamp and pvc
Note: You'll probably have to grease it
Again, I'm sorry if this has been thought of already. Most things I post have either failed or already thought of (not intentional).
I haven't tried to make this yet but will soon (I'll probably see the replies first though).
I hope I have contributed to the community.
~Lokoyo
My idea is to use a hot glue gun to make a breech.
(1) So you get a sample of the barrel and you get a larger size pipe
(2) Fill in the space (Inside the larger pipe and outside the smaller barrel [The barrel size you'll be using]) with hot glue.
(3) Now you should now have a cylinder with a hole in it.
(4) Create a handle. I have seen other breeches created with a hose clamp and pvc
Note: You'll probably have to grease it
Again, I'm sorry if this has been thought of already. Most things I post have either failed or already thought of (not intentional).
I haven't tried to make this yet but will soon (I'll probably see the replies first though).
I hope I have contributed to the community.
~Lokoyo