SpudFiles

hey this is a floating O-ring piston i made for an 8mm coaxial pneumatic
the piston is made of a section of 8mm ID aluminium tube with epoxy coating and end plugs (in the photo it is just aluminium foil, but is going to be the filler) sealing face is attached with a screw and an O-ring for the check valve, fits 13mm ID chamber, tell me what you think, questions are welcome

did you make the oring groove with a hand drill?

Lockednloaded wrote:did you make the oring groove with a hand drill?

yea, the epoxy part was easy and i only hat to take like 1/2mm of the aluminum tube so it wasnt that hard, just a little awkward

Very nice, is this for the cane gun?

jackssmirkingrevenge wrote:Very nice, is this for the cane gun?

thank you, no this is for a shotgun stile launcher, still waiting for the shop to get the right sizes pipe for the cane gun

ilovefire wrote:the cain gun

Will you be using it toblow the bloody doors off

I think some body's been paying attention. A simple yet surprisingly effective way to control internal flow of the valve.

Should work very well, but the porting in the groove is larger than it needs to be.

Yer gonna like the way it works.

jackssmirkingrevenge wrote:

ilovefire wrote:the cain gun

Will you be using it toblow the bloody doors off

ha ha ha, edited to fix spelling mistake

Gippeto wrote:I think some body's been paying attention. A simple yet surprisingly effective way to control internal flow of the valve.

Should work very well, but the porting in the groove is larger than it needs to be.

Yer gonna like the way it works.

yea well i thought i would give something like that a go because i found a O-ring that was almost a perfect fit, but the funny thing is i didnt even use it i bought a better one