How do i make this semi auto?
Posted: Tue Aug 30, 2011 2:20 am
Earth's largest potato gun resource
https://www.spudfiles.com/
i mean like a shot every time you press the trigger, couldn't i use a blowgunjackssmirkingrevenge wrote:http://www.ebay.com/itm/Slide-shut-off- ... 1c18e5e48e
I don't think tape will cut it, epoxy remember it doesn't need to be more than 1mm diameter.Goats spudz wrote:i think it may have been a little big shall i tape over it and poke a smaller one through the tape (insulation tape)
can you post it before you take it to 55bar, that kind of pressure is nothing to be playing with.Goats spudz wrote:I covered the hole and changed to a 1.5mm drill bit (the smallest that will fit in the chuck) and put the hole in the right place this time (i put the big one that's covered where the thin rubber is :L) and it works but with my bike hand-pump i can get 2 shots from it, if i get a fridge compressor and take it to about 55 bar will i get lots of high power shots?
most of it is high pressure hydraulic fttings and the tank is rated to 3000 psiCrna Legija wrote:can you post it before you take it to 55bar, that kind of pressure is nothing to be playing with.Goats spudz wrote:I covered the hole and changed to a 1.5mm drill bit (the smallest that will fit in the chuck) and put the hole in the right place this time (i put the big one that's covered where the thin rubber is :L) and it works but with my bike hand-pump i can get 2 shots from it, if i get a fridge compressor and take it to about 55 bar will i get lots of high power shots?
... but like a chain, it's only as strong as the weakest componentGoats spudz wrote:most