Page 1 of 1

Paintball sniper

Posted: Wed Jan 25, 2012 3:07 pm
by Moggle NZ
just a picture of the setup i might use just wondernig what i can in pvove on such as
metirals
airflow
just any thing

when u pull the bolt back the ball valve will open
and close when u push formards so u can have muliple shots


Image


wh

Posted: Wed Jan 25, 2012 5:17 pm
by jrrdw
Looks like your air will be restricted. That's good for repeated shooting but bad for power.

Posted: Wed Jan 25, 2012 6:40 pm
by Gun Freak
Not a very practical design. There are easier ways to do it. Why a hammer valve and a ball valve?

Posted: Wed Jan 25, 2012 10:24 pm
by Moggle NZ
that is why i posted it asking for halp then u just tell me whats bad not tell me what i can do to impove it

Posted: Wed Jan 25, 2012 10:32 pm
by Gun Freak
1. Too much dead space

2. Bolt is overly complex

3. Make the air chamber one part (not two with a ball valve)

I would like to say though that the actual valve part looks doable with a little creativity. But, what pressure are you going to use? It will take a lot to get paintballs flying.

Posted: Wed Jan 25, 2012 10:39 pm
by Moggle NZ
ok thanks gun freak i was thinking instead of a valve useing a solenoid valve is
15mm an ok size
or shud i opt for the bigger 25mm
i would prefur the smaller 1 for look reasons only

Posted: Wed Jan 25, 2012 11:03 pm
by Gun Freak
I'm no sure you can get multi-shot on a ssolenoid valve... Have you given thought to a three-way valve?

Posted: Wed Jan 25, 2012 11:22 pm
by Moggle NZ
you can ive seen it done b4

Posted: Fri Jan 27, 2012 1:16 am
by Moggle NZ
is a 15 mm solenoid valve an ok size for this gun?