Page 1 of 1
home made hammer type valve
Posted: Sun Jan 29, 2012 9:45 pm
by Moggle NZ
made in about 5 mins very simple made from bits i found in my sheed
this is not the 1 i will use a on a gun im makeing i just made it to see
i would preffer to make a good 1 out of a soilid bloc of alum
the qev
explaind a bit
Posted: Sun Jan 29, 2012 9:55 pm
by evanmcorleytv
Looks good!! I'd like to see a launcher accompany it!!
Posted: Wed Feb 01, 2012 1:50 pm
by quark1980
agreed
did you have one in mind?
Posted: Wed Feb 01, 2012 6:20 pm
by Zeus
If you put a female tee on the outlet of the valve, then put the barrel all the way through and seal it with epoxy, drill a hole for the air inlet and make a bolt, you'd have a very nice launcher.
Posted: Wed Feb 01, 2012 6:42 pm
by Gun Freak
That tee looks like compression... If I could find male tees I would have probably made my valve. Looks good...
Posted: Thu Feb 02, 2012 10:53 am
by quark1980
Zeus wrote:If you put a female tee on the outlet of the valve, then put the barrel all the way through and seal it with epoxy, drill a hole for the air inlet and make a bolt, you'd have a very nice launcher.
yup thats basicly what i did, except i used aluminium and steel
you still would need a hammer mechanism... any toughts on that?
Posted: Thu Feb 02, 2012 3:01 pm
by jakethebeast
in-line hammer would be quite simple to make