Page 1 of 1

easy to make piston

Posted: Mon Oct 16, 2006 12:53 am
by haulinick
I found some stuff at homedepot today called epoxy putty. There is many different kinds around the store included plumbing and all purpose. I just got the all purpose. I simply took a piece of the pipe i needed it to fit in and greased it up. Then mixed up some of the putty and molded it into the pipe. It takes about 20 minutes to harden and about an hour to fully set. I cut a flat piece out of a rubber pipe cap to uses as a screw on gasket.

Posted: Mon Oct 16, 2006 1:04 am
by killagorrila99
Hmmm, I think its been done...


In other words:

;;;;;;;;;;;:¸_____________, :;;;;;;;;;`¸
`:;;;;;;;;;;;`;__________, :;;;;;;;;;;;`¸
_ `:;;;;;;;;;;;`, , _______, :;;;;;;;;;;;`¸
___`:;;;;;;;;;;;;_______, ;;;;;;;;;;;;:
____.`·¸:;;;;;;;;;¸_____¸;;;;;;;;;;`
_______`·¸:;;;;;;¸_____¸;;;;;;;:´
___________`·¸:;;;;¸., .¸;;;;;;·
______¸.·;;;;;;;;;;;;;;;;;;;;;;;
____.´;;;;;´D`;;;;;;;;;;;;;;;;;;;
____`;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
_____`:;;;;;;;;;;;;;;;;;;;;;;;;;;
_______`·.;;;;;;;;;;;;;;;;;;;;
___________.;;;;;;;;;;;;;;;;;.
____(`*·.¸ (`*·.¸ ¸.·*´) ¸.·* )

Posted: Mon Oct 16, 2006 1:49 am
by haulinick
what are you tryin to say, killa? I think Im missing something here.

Posted: Mon Oct 16, 2006 3:18 am
by SquishY
Don't mind him, hes on a new med(not really from what I know). Nah I dunno man, I've never seen anything about this being done to make a piston but good job on that. Is it soft enough to make a bumper also or does it actually get hard?

Posted: Mon Oct 16, 2006 3:25 am
by killagorrila99
Its called crystal meth dude, get with the program :P :P :P :P :P nah im kiddin, this idea is good, but has been done. Do your reasearch.

Posted: Mon Oct 16, 2006 5:46 am
by rna_duelers
I used this on the end to my piston,worked well.

Posted: Mon Oct 16, 2006 6:59 pm
by pyromanic13
john, what was you avatar before?