Page 1 of 1

watermaster 3/4 leeking slowly out the barel

Unread postPosted: Tue Mar 27, 2007 7:45 pm
Author: mopherman
i modded a 3/4 sprink and i have to use a ball valve in front of it to make it seal. the problem is that it doesnt seal compleatly. it lets air out the barel slowly and i can only get a shot off if I work quickly.
thanks

Unread postPosted: Tue Mar 27, 2007 8:05 pm
Author: WOW!!
Can you get a pic of the valve?

And did you take the selonid off of it and seal it?

Unread postPosted: Tue Mar 27, 2007 8:06 pm
Author: pyromaniac
you told me you bought the orbit off amzon?

Unread postPosted: Tue Mar 27, 2007 8:08 pm
Author: mopherman
i left the solenoid on cause i dont have any epoxie on hand.

Unread postPosted: Tue Mar 27, 2007 8:09 pm
Author: mopherman

Unread postPosted: Tue Mar 27, 2007 10:52 pm
Author: noname
Take it apart and clean the diaphragm. Put some heavy grease on top of the diaphragm to weight it down.

Unread postPosted: Wed Mar 28, 2007 3:48 am
Author: hi
you need to epoxy up the solenoid hole at the top. That is, assuming that you are planing to modd it.

Unread postPosted: Wed Mar 28, 2007 6:49 am
Author: jrrdw
Could be something on the diaphram, take it apart and check both sides of it, then lube it.

Unread postPosted: Thu Mar 29, 2007 6:00 pm
Author: mopherman
can i just yank the phram?

Unread postPosted: Thu Mar 29, 2007 6:06 pm
Author: noname
What!? You could make your own diahragm.

Unread postPosted: Thu Mar 29, 2007 6:08 pm
Author: mopherman
i cant even make this siaphram work! i just need to know hopw to remove the damn thing.

Unread postPosted: Thu Mar 29, 2007 6:45 pm
Author: mopherman
just cleaned the diaphram. works like a champ