SpudFiles

I was just wondering if there is anyway to mod a blow gun to make it flow more air? I did a search but all i could find was moded sprinkler valves. Any help would be appreciated

I would think that you can drill the hole inside a little bigger providing you don't go bigger than the trigger system inside, and that you don't drill into the trigger system. That would be a bad thing LOL just make sure that you clean out all shavings from dilling so it dont mess up the rubber seal inside hope that helped a little. I haven't done the Pnuematic thing yet but will do after the contest. All I know about blow guns is by what I read. I like copper it is shinny LOL that's what I'm using next, just got to practice soldering copper.

yes there most certainly is to answer you question,

http://www.spudfiles.com/spud_wiki/inde ... dification

thanks chaos, and arctic wolf

anytime mate.

just be sure to search as much as ya can (not being mean btw)

No problem. Thats what were here for to help one another. LOL

Oh yer i forgot to say, now that we helped you you have to vote #1 s400 in the contest. sorry i should put a disclaimer on my posts lol




jokes, but still...S400~ by Chaos #1

yea, i will think about voting for the s400.