Page 1 of 1
close nipple piston housing??
Posted: Wed May 23, 2007 6:19 pm
by mopherman
do you think a 1-inch close nipple would be big eneugh for piston housing?
If not, would like 1.5 inches work?
Re: close nipple piston housing??
Posted: Wed May 23, 2007 6:49 pm
by Velocity
mopherman wrote:do you think a 1-inch close nipple would be big eneugh for piston housing?
If not, would like 1.5 inches work?
Certainly. If I were you, I would get a hex nipple, preferably made of brass for their smooth interiors. It costs $10 off of mcmaster though, so you might have to find something else...
Posted: Wed May 23, 2007 6:52 pm
by mopherman
as an altearnative to the hex nipple , do you think i could just use my dremle tool to smooth the inside of the pipe?
Posted: Wed May 23, 2007 7:25 pm
by Velocity
It would not work as well, but it certainly would work fine. I just like the polished finish on the inside of brass nipples; seems perfect for a piston housing.
Posted: Wed May 23, 2007 7:59 pm
by spudthug
i just used a 1 inch by 3 inch nipple on my newest piston gun (shotgun) and i used an iron nipple that was bored out...its smoother than the brass ones i found at my local hardware store... although i did mine with a lathe and a bunch of special polishing tools at my dads shop...
Posted: Wed May 23, 2007 8:17 pm
by mopherman
Thug, do you think a dremmle with a sanding wheel and a polishing attachment could work?
EDIT: rmich, do you ever go to hardware stores, or just mcmaster? It seems like it would cost a lot in shipping
Posted: Wed May 23, 2007 9:38 pm
by GinsuGuy585
Yes a dremmel with a sanding drum would work.
McMaster ships from Buffalo NY (one of their distribution plants is there) and I'm like a 1hr drive away. So while it still costs a bit for shipping, stuff arrives almost next day.
Posted: Wed May 23, 2007 9:40 pm
by Velocity
Like GinsuGuy, my mcmaster carr is very close; an hour away. Everything comes next day, and the shipping is usually $6.
However, I do still go to hardware stores. I have found that the supplies at the hardware stores is not as high of a quality as at mcmaster. Furthermore, they do not have as good of a selection. I get things like copper and such from hardware stores still, but I like to get everything else from mcmaster. Its all pressure rated, I can get tons of things, and it comes immediately.
Posted: Thu May 24, 2007 7:43 am
by mark.f
If nothing else, you may want to give copper a try. Maybe you could just build the valve out of copper, and the rest out of whatever you want to?
Or, you might just grind out the weld seam on the inside of the pipe. After that, the inside would be pretty smooth, and roughly cylindrical, for your O-ring seal or whatever, (I use duct-tape a lot
).