Drilling into the pressure chamber?
Posted: Thu May 12, 2011 4:06 pm
Hey guys, new here. Got a question...........
Working on a combustion spud gun with a 1:1 C:B ratio. The chamber is also the same dia. as the barrel. It is not meant to be a super high performance spud gun and is achieving the results I want.
My question is this........
Is it ok to drill into the pressure chamber in multiple places for mounting purposes? Two hoes will be for mounting, and 1 or 2 for ignition. Not sure if I will use the end cap location for the ignition wires.
1.5" sch 80 with 2, 1/4 mounting bolts? Hoping it wont explode on me?
I'll post my project up once I get a bit more progress.
Working on a combustion spud gun with a 1:1 C:B ratio. The chamber is also the same dia. as the barrel. It is not meant to be a super high performance spud gun and is achieving the results I want.
My question is this........
Is it ok to drill into the pressure chamber in multiple places for mounting purposes? Two hoes will be for mounting, and 1 or 2 for ignition. Not sure if I will use the end cap location for the ignition wires.
1.5" sch 80 with 2, 1/4 mounting bolts? Hoping it wont explode on me?
I'll post my project up once I get a bit more progress.