Harness the power of precision mixtures of pressurized flammable vapor. Safety first! These are advanced potato guns - not for the beginner.
-
SpudStuff
- Sergeant 5
- Posts: 1410
- Joined: Sat Dec 10, 2005 3:55 pm
- Location: Cupertino, California
-
Contact:
Sat Sep 16, 2006 7:20 pm
You need to have a piece of acrual pipe threaded for this. thoes Molded Sprinkler risers just win't cut it. They are thick but often have defects.
-
Benny
- Corporal 4
- Posts: 844
- Joined: Wed Apr 19, 2006 8:21 pm
- Location: Tasmania, Australia.
Sat Sep 16, 2006 7:38 pm
noname are you australian?
Join the spudshot forum!!!!!
F*ck the bunny... i got a fishy ><>
-
Benny
- Corporal 4
- Posts: 844
- Joined: Wed Apr 19, 2006 8:21 pm
- Location: Tasmania, Australia.
Sat Sep 16, 2006 7:46 pm
Ahh, ok.
Join the spudshot forum!!!!!
F*ck the bunny... i got a fishy ><>
-
noname
- First Sergeant 4
- Posts: 2698
- Joined: Mon Apr 10, 2006 9:19 pm
- Location: Bay Area, CA
Sun Sep 17, 2006 11:02 am
Spudstuff, by sprinkler risers do you mean the different lengths of SCH 80 3/4" and 1/2"? Most of them around here actually say "3/4" SCH 80 940 PSI @ 73 DEGREES" and then all the ASTM ratings and stuff like that. At Ace Hardware, in the back they have pipe cutters and dies going from 1/8" to 2", so I'll just get a piece that has the pressure rating on it, cut it to size, then use a 3/4" or 1/2" die to thread both ends.
-
SpudStuff
- Sergeant 5
- Posts: 1410
- Joined: Sat Dec 10, 2005 3:55 pm
- Location: Cupertino, California
-
Contact:
Sun Sep 17, 2006 3:05 pm
Oh okay then. The Home Despots (had to do that) only have molded ones.
-
Jolly Roger
- Specialist 2
- Posts: 210
- Joined: Fri Aug 25, 2006 4:20 am
Tue Sep 19, 2006 8:20 am
Hey dude, I'm just not sure bout your BBQ lighter thats all. Your gaps are going to have to be really small being such as dense mix. You could incorporate a capacitator into the design. And did your little sister draw that design for you? (Sorry man had to say it)
-
spanerman
- Specialist 4
- Posts: 437
- Joined: Sun Sep 17, 2006 2:54 pm
Tue Sep 19, 2006 2:26 pm
you are goin to need a realy smal gap with tht mix id say use a disposable camera curcuit and double up on capasitors and use the bolt through and jb weld
peace,sam.
-
noname
- First Sergeant 4
- Posts: 2698
- Joined: Mon Apr 10, 2006 9:19 pm
- Location: Bay Area, CA
Tue Sep 19, 2006 7:17 pm
I'll just make a really small gap.
Jolly Roger, I don't even have a little sister. It was just a rush job using only the pencil in Paint.