Page 1 of 1

Mini Hybrid Chamber Type M Copper

Posted: Mon Jan 12, 2009 6:42 pm
by spudkilla224
Hello i am doing research on hybrid cannons and i was using HGDT and i'm using a 3/4" "Type M" Copper Chamber as my combustion chamer, it says that it will have a combustion pressure of 408 PSI.

Can Type M Copper Handle 408 PSI?

Posted: Mon Jan 12, 2009 7:40 pm
by pizlo
Yes, just make sure your solder joints are very well done.

Posted: Mon Jan 12, 2009 7:43 pm
by starman
That's mighty small chamber. In any case, I would probably go with Type L, but M should hold it.

Posted: Mon Jan 12, 2009 8:22 pm
by daccel
As I was referred, so I shall refer: Copper tube handbook.

I've used 3/4 L at 8.5x without a problem, but make sure you check out the specific size/type you end up using at the above link.