I based it off a paintball gun not sure of what paintball gun tho. Its made basicly out of plumbing parts. Runs at about 110psi (co2). I still half to finish the top bolt, in the vid i dont have the top on since it isn't finished, but thiers a pic of what it will look like when its done. I also plan on putting a hop up system in. Any questions or if you want better pics just ask.
[youtube][/youtube]
Sorry for the small pics click them and they get bigger. Also wasnt sure were to put this since it isn't finished so mods move it if it should be in showcase. Sorry.
Posted: Tue Jan 20, 2009 1:46 pm
by jackssmirkingrevenge
Looking good didn't quite get how it works though, is there a hammer valve somewhere? A diagram would be most helpful.
Posted: Tue Jan 20, 2009 1:56 pm
by Cannibal Corpse
O i knew i forgot to take a pic of the valve thanks for the reminder. Well see that elbow were the disconect for co2 is. The valve is the elbow. Yea its a hammer valve.
Posted: Tue Jan 20, 2009 2:10 pm
by Hubb
Could you sketch up a diagram of the valve? Please?
Posted: Tue Jan 20, 2009 2:21 pm
by starman
To show the pics larger, you can use the "direct link" provided by Imageshack instead.
Posted: Tue Jan 20, 2009 2:45 pm
by ALIHISGREAT
i too request a diagram of the mechenism... you;re video lacks inthe clarity departement
Posted: Tue Jan 20, 2009 2:48 pm
by Cannibal Corpse
Sorry the vid was fine until it got uploaded to youtube. But yea im working on it.
Re: Full Auto airsoft gun (WIP)
Posted: Tue Jan 20, 2009 3:05 pm
by Hotwired
Cannibal Corpse wrote:I based it off a paintball gun not sure of what paintball gun.
Oi, so it's a blowback hammer valve! Nice work! Do you regulate the CO2, if so, what psi?
Posted: Tue Jan 20, 2009 5:15 pm
by Cannibal Corpse
Thanks. Yea i run regulated co2 right now im at 110psi.
Posted: Tue Jan 20, 2009 8:04 pm
by Lentamentalisk
My god that is insanely great! Really good work. You might not have noticed, but there has been a sudden increase in the search for a full auto design that really works, and you seem to have accomplished something great here.
Nice going!
I look forward to seeing your final results.
Props for getting it to work This was my take on the idea, never made it though.
Posted: Wed Jan 21, 2009 7:16 pm
by psycix
The big point with these types of guns is mostly that you need to tweak it right. Have you also tested it with different pressures? And did you have to tweak stuff (like weight of hammah and spring strength)?
didn't quite get how it works though, is there a hammer valve somewhere? A diagram would be most helpful.
