SpudFiles

You can see the fittings I used in that pic, also in my thread. Just unscrew the head of the extinguisher and then JB weld the new fittings in. I had to use the fitting on the head because none others would fit the threads. Then I added a fill valve. I also added to mine a regulator and a ball valve, then a quick connect to connect it to my gun. You can get schrader valves with threads from a hardware store.

yeah i checked home depot a while back, i asked the employees and they had no clue what the hell a schrader valve was

nosebleedXD wrote:they had no clue what the hell a schrader valve was

Ragnarok's Top Tips #372: If a store employee does not recognise the name "Schrader valve", try asking for a "car tyre valve" instead.

wait i think i found one on ebay http://cgi.ebay.ca/brass-fitting-schrad ... 3a5999dfff

Do you have an O'reillys or a Pepboys near you? You could just buy them there.

naw they dont have any of that stuff in canada, if i just went to a random auto store, would they sell schrader valves for hopefully less than 10 bucks

hey, i found a store which sells everything =] gonna check it out in a bit

http://www.homehardware.ca/Products/ind ... nap_in_2pk

http://www.homehardware.ca/Products/ind ... /N//page/2

http://www.homehardware.ca/Products/ind ... ion+spring

Yeah they normally sell the schraders without threads at auto stores, I think.

Yeah they do but you can shave them down a little and epoxy them I'm a 1/4 pipe nipple

yeah im just gonna buy a super long pvc pipe and cut it up into thirds and make a tank out of it

because i checked home depot for pressure rated pipes but they didnt have any

but home and hardware have pipes =]

Home depot doesn't have pressure rated pipes?

clemsonguy1125 wrote:I'm a 1/4 pipe nipple

Ok then

at least not the one near my area, ill give you guys a picture later, i'm not sure if its pressure rated but the fittings that were sold along with it i saw were not pressure rated for sure

I've said it like a billion times, Easton X7 eclipse arrow shaft size 1714 is the PERFECT non-commercial airsoft barrel. Please just go online and get some off an archery store, they're pretty cheap, and really long.

the only pipes i see at the home depot NEAR my house is the picture i have below which i dunno if its pressure rated but the fittings they sold with it were not pressure rated for sure as it had rings around the fittings

and some of the pipes i saw had giant holes every couple feet in the pipe but here is a picture below of the pipe they had for sale