Page 1 of 1
Single Shot Gun
Posted: Sat Mar 17, 2007 1:31 pm
by Tom Hogan
Hi. I am interested in making an airsoft/bb single shot rifle. I am using a modded blowgun connected to a barrel on one end, and a PVC chamber on the other. I was wondering how I should do the tubing connecting the blowgun to the chamber. Do I need to buy a set of blowgun fittings? Any help would be appreciated.
Thanks.
Posted: Sat Mar 17, 2007 1:54 pm
by PVC Arsenal 17
Tubing? All you need is a couple barbed fittings that match the ID of the tube you plan on using.
Posted: Fri Mar 23, 2007 2:36 am
by Thursto
And make sure when you buy barbs that they screw into your blowgun nicley, even use a bit of Plumbig tape, and then slide over one of those clips that when you screw wid a screw driver it tightens up, this will help seal the air.
Posted: Fri Mar 23, 2007 9:35 am
by experament-u2
there called hose clamps and they work rely well
just a question would a gul like this work well for shooting cans with steel bbs or would it suck?
Posted: Fri Mar 23, 2007 10:30 am
by Flying_Salt
experament, from what I've heard, blowguns can work pretty good for small bb guns, so it would probably be good for shooting cans.