Page 4 of 4

Posted: Mon Jul 18, 2011 4:21 pm
by clemsonguy1125
Thats an even better idea.

Posted: Tue Nov 01, 2011 3:58 pm
by warhead052
Sorry for the bump. But I finally got around to trying to shoot a cork, and it didn't work. All I heard was a pop of the burst disk and then pfff of the cork just sliding a bit. Didn't even clear the barrel. :? Any suggestions? Again sorry for the bump.

Posted: Tue Nov 01, 2011 5:59 pm
by saefroch
Sounds like a bad mix. This thread may be of interest.

Posted: Tue Nov 01, 2011 8:57 pm
by warhead052
Thanks, I will check that out right now.

Posted: Fri Nov 04, 2011 3:14 pm
by warhead052
Double post again, I know... But I ran into a problem. Butane is no longer working, even at a 1x mix. I double layered the pvc with a 1 1/4" ID pvc pipe, and filled with epoxy and hot glue, but the butane won't ignite. The spark gap is about 10mm, and I get a nice big fat spark from it, so that can't be the problem. It may be the burst disks not breaking at a low enough pressure, I may try it again with a different type.