Page 2 of 7

Unread postPosted: Fri Jun 24, 2005 6:51 am
Author: spudshot
OH ok, well there should be a piece of metal at the bottom of the peizo which you tape/solder wire too, and there should also be either a wire, or a metal tab on the side somewhere you tape/solder another wire to

Unread postPosted: Fri Jun 24, 2005 4:14 pm
Author: saladtossser
there are two types, a bad one is black and has a big metal cylinder on the bottom that solder doesnt stick to, a white one will have 2 small electrobs that are easily solderable(is that a word?). use the white one.

Unread postPosted: Fri Jul 29, 2005 5:42 pm
Author: saladtossser
thats 3 posts of the exact same thing
a big one wouldnt hurt, a small on wouldnt hurt too, just dont choke the flow and keep a good c:b ratio. i think the only advantage of a big chamber is that u can fit a fan in it, but a 2" chamber ignites just fine without one.

Unread postPosted: Mon Aug 01, 2005 3:54 am
Author: crod
so wait...all u have 2 do is spry the fuel down the barrel put the Q tip in and press the igniter button?

Unread postPosted: Mon Aug 01, 2005 6:47 am
Author: spudshot
you put the q tip in first to stop the fuel (you spray in from the bottle cap) from escaping out the barrel, the ignitor is wired to 2 screws on the gun so the electricity will make a spark

Unread postPosted: Sat Aug 20, 2005 12:02 pm
Author: Bedo
hey i was just wonderin how big yur pill bottle is?

Unread postPosted: Tue Aug 23, 2005 1:57 pm
Author: Hal0 x
That s pretty cool..wish i was good enuogh to make somthin like that...alas im a a noob at this.

Unread postPosted: Sun Aug 28, 2005 7:21 pm
Author: goatwrangler500
haha thats allot of fun i used spray paint for it but i usuly have to air it out a bit before it will shoot y is that :?:

Unread postPosted: Sun Aug 28, 2005 7:37 pm
Author: spudshot
because there is too much fuel in it, i wouldnt use spray paint, it'll leave a residue, and if its an oil based paint it might just burn. try using a spritzer bottle of cologne, a small spritz is the perfect amount

Unread postPosted: Sun Aug 28, 2005 9:05 pm
Author: goatwrangler500
iv been shooting spit wads through it :P

Unread postPosted: Tue Sep 06, 2005 1:09 am
Author: deathtodeer666
hey be careful when you solder a piezo igniter because they melt real easy

Unread postPosted: Tue Sep 06, 2005 2:20 pm
Author: saladtossser
i did it once, no problem, just be quick.

Unread postPosted: Tue Sep 06, 2005 5:05 pm
Author: Bedo
i used epoxy to glue the pen tube to the pill bottle but the epoxy just flaked off so i took in apart

would hot glue work fine?

Unread postPosted: Tue Sep 06, 2005 5:06 pm
Author: saladtossser
not fine, it will work a few times, and get weakened

Unread postPosted: Tue Sep 06, 2005 7:15 pm
Author: Bedo
hm....then what else could u use besides taping it down?

i was also thinkin of gorilla glue or anyother type of super glue?