Page 1 of 1

pump action shotgun design

Posted: Thu May 22, 2008 2:10 pm
by pat123
I am thinking about building an airsoft shotgun. I made a design in paint.

as the piece of wood is pulled back(don't know what it is called) the rod attached to the end pushes the ball valve open. the rod on the other end pushes the ammo forward into the barrel. do you think this will work?

Posted: Thu May 22, 2008 2:22 pm
by MrCrowley
Well for starters I don't see that ball valve opening 100% with the rod.

Your projectiles are too long, they can't navigate the 45 degree bend and still fit through a ball valve.

You're going to see a lot of jaming in this design.

Posted: Thu May 22, 2008 2:32 pm
by trollhameran
I made a design pretty much exactly the same as this a while back, ill try dig up the thread and link you to it so you can look at my designs.

edit: Mr crowley, is there a way i can find all the threads ive made in the past?

Posted: Thu May 22, 2008 3:24 pm
by pizlo
Click on your name in the above post and then click find all posts by this user.

Posted: Thu May 22, 2008 4:03 pm
by psycix
As MrCrowley said: this is not going to work with such projectiles.

But I think that spherical ammo might work. Only make sure it doesnt fall back into the closed ball valve.

Posted: Thu May 22, 2008 4:21 pm
by trollhameran
http://www.spudfiles.com/forums/viewtop ... tml#147187
heres the topic i made with this sort of design, lots of good info in there