Page 2 of 2

Posted: Sat Mar 14, 2009 3:33 pm
by SpudFarm
that is what i used for the marble gun, stood up to thousands of hits with bolts and marbles (yes i did shoot EVERY day)...

consists of a strip of 1/4" steel about 40cm wide that is bent after the pattern in the picture, two 1/4" plates welded to the sides so the projectile does not bounce out the side and some lead to keep it upright. the lead can be replaced with a bar welded to the bottom that you force in the ground.

simple to make and REALLY strong. you just need some tools. made in a an hour at a good shop so you does not have to pay much to get it made either.

i made multiple other models aswell but not a single one of them held up against a high speed golfball...

Posted: Sat Mar 14, 2009 3:59 pm
by CS
As Grock suggested I have made a similar type of "hard" 45* backstop. I just used glue lams for the back stop and just threw some sand underneath it.

Image
[Glue lams- Usually you can find 1-4' cut-offs at lumber yards for free or at least cheap. Makes a great sub-bench top too!]

I've also hung scrap carpet as well. More the better.

Posted: Sat Mar 14, 2009 4:04 pm
by D_Hall
Personally, I just use 100 acres or so of open land and avoid "max range" type shots.

Posted: Sat Mar 14, 2009 5:26 pm
by jonnyboy
Do you have a hill behind you?

Take some big pieces of plywood and place them into the hill at 90*. So you have the hill and two plywood sheets that make a sort of enclosure minus the roof. Then just fill it with sand or dirt.

Posted: Sat Mar 14, 2009 7:01 pm
by psycix
I made a backstop from particle board, but I found a marble that just went through three empty cans to bounce back with quite a bit of velocity and hit me on my cheek... :shock:
I chose the particle board because I was afraid of using a "hard" backstop with potential of shrapnel flying in random directions. But I once fired at a computer case, and that resulted in just a bit of dust.
With the particle board, the marble just penetrates in almost an inch and then bounces back!

Posted: Sat Mar 14, 2009 8:09 pm
by jook13
I like jsr's idea of a sizable box (about 2x2x2 feet). Then throw a bunch of cloth in there. I couldnt get a marble at 400 psi through it.

Of course, I am also lucky enough to have hundreds of miles of forest behind me, so a backstop is not a big concern of mine.

Posted: Sun Mar 15, 2009 2:10 am
by sssssbooom
What I use is a shoe box full of paper, magazines, phone books, but your using golf balls so a bigger box and lots more paper might work. works for me anyways and it is cheap

Posted: Mon Mar 16, 2009 11:39 pm
by SpudBlaster15
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.