Page 1 of 1

Rubber Source

Posted: Fri Apr 14, 2006 11:08 pm
by Atlantis
i recently found a "Giant Eraser." It's about 3/4" thick and about 3X2 Inch wide. Could this be used for a piston rubber face?

Posted: Fri Apr 14, 2006 11:51 pm
by SteamRoller
You could, i guess. You probably want to use a softer rubber though, like neoprene.

Posted: Sat Apr 15, 2006 3:09 am
by )DEMON(
it depends on how you cut it

Posted: Sun Apr 16, 2006 2:40 pm
by Atlantis
Hey I could always try it then use something else if it doesn't work.

Posted: Sun Apr 16, 2006 2:56 pm
by )DEMON(
the rubber bit in a syrindge should work nicely because it is soft

and i wouldnt mind any body donating 60 spudbux to me (hint hint)