Page 1 of 1
help with pass thru barrel for breech loading
Posted: Sat Aug 01, 2009 3:33 pm
by geniusbomberman
I am building a 1" barrel for a gun, and am wondering what size male adapter I should use. It is modeled after boogieman's plans found here:
http://www.advancedspuds.com/breechmethod.gif
Re: help with pass thru barrel for breech loading
Posted: Sat Aug 01, 2009 3:50 pm
by spudtyrrant
1 inch lol
Posted: Sat Aug 01, 2009 3:58 pm
by mark.f
Uh, no.
Use a 1-1/2" male adapter and a 1-1/2" x 1" bushing.
Posted: Sat Aug 01, 2009 5:22 pm
by geniusbomberman
thanks for the help with this design
Posted: Sat Aug 08, 2009 12:29 pm
by sgort87
If you want to keep it smaller, you could use a 1.25" adapter instead of 1.5", but that would keep you from being able to use bigger barrels with maximum power. If you won't go higher than 1.25, then go with that.
Posted: Sat Aug 08, 2009 3:17 pm
by King_TaTer
Gort! It's been a while. Nice to see your alive.
Anyway, genius do you have a picture of the gun? Or are you still planning? Depending on your configuration and what fittings you used you may be able to use cam locks. this would make breech loading a cinch for your 1" barrel.
