I've been searching for over an hour and I can't find the thread that I'm looking for. (But I would be willing to bet that JSR can find it within 10 seconds ).
I'm looking for a picture of a tripod that another member build a while ago. I'm fairly certain that it was built out of 2x4's and it had a cylindrical assembly where all of the legs met. I also think that the gun mounted on it was some a medium-sized over/under type cannon.
jackssmirkingrevenge wrote:Darn it, that's exactly the one I was thinking of!
Same here 8)
Thanks for the help from both of you, that is the one I was looking for. A tripod like that will make a great stand for the 6mm sentry that I'm building.
Posted: Thu Feb 17, 2011 9:36 am
by jackssmirkingrevenge
potatoflinger wrote:the 6mm sentry that I'm building.
ooh! auto-targeting?
Posted: Thu Feb 17, 2011 7:59 pm
by potatoflinger
jackssmirkingrevenge wrote:
ooh! auto-targeting?
Of course
I'm going to attempt the arduino controlled version that Poland_Spud posted a link to in your sentry project thread.
Posted: Fri Feb 18, 2011 12:20 am
by jackssmirkingrevenge
Good luck with it I'm back to the drawing board with mine, decided to swing back to 3mm calibre.
Posted: Fri Feb 18, 2011 11:02 pm
by potatoflinger
Thanks, I'm going to need all the help I can get with this project. I have most of the hardware portion figured out already, but the software end is the part that I'm not very familiar with. I am learning a lot though.