Page 2 of 2
Posted: Mon Mar 14, 2011 7:54 pm
by Lockednloaded
I've got some epoxy based paint that may be a little safer to use on a PVC pressure vessel. I used it on my most recent paintball semi, and it didn't chip after a full day of woodsball. The only downsides are that it takes a full day to cure/dry, and I haven't found it in many colors
Posted: Mon Mar 14, 2011 8:18 pm
by mark.f
Do you mean the appliance epoxy paint (the stuff you paint toaster ovens/etc. with)? If so, it is tough stuff.
Posted: Mon Mar 14, 2011 9:19 pm
by Davidvaini
The way i see it, you are trying to dye plastic... i think any method you try is going to have the potential of weakening the PVC, I figure a product made for PVC will have a better chance of holding up than a product not made for PVC...
and penetration still isnt anywhere close to half of the width of the pvc walls, so pressure i believe will be fine unless you are running close pressures that are right at the pvc pressure rating...
Most of the PVC is left untouched and i dont think it will be a problem. Of course when I test, I will test behind the wall and i will test throughly .
Posted: Mon Mar 14, 2011 9:21 pm
by Davidvaini
Lockednloaded wrote:I've got some epoxy based paint that may be a little safer to use on a PVC pressure vessel. I used it on my most recent paintball semi, and it didn't chip after a full day of woodsball. The only downsides are that it takes a full day to cure/dry, and I haven't found it in many colors
t
I have tried epoxy based paints and though they hold up better than spray paint they still scratch.
Posted: Mon Mar 14, 2011 9:32 pm
by Davidvaini
I am also going to try to use different dyes with pvc cleaner/primer including RIT dye...
Sorry for the triple post, i was not paying attention at all..
oh well we are all given one slip up.
Posted: Mon Mar 14, 2011 9:44 pm
by Lockednloaded
Davidvaini wrote:Lockednloaded wrote:I've got some epoxy based paint that may be a little safer to use on a PVC pressure vessel. I used it on my most recent paintball semi, and it didn't chip after a full day of woodsball. The only downsides are that it takes a full day to cure/dry, and I haven't found it in many colors
t
I have tried epoxy based paints and though they hold up better than spray paint they still scratch.
It really must've been a cheap brand, or you didn't apply 2 even coats. I accidentally painted a part that should've been taped, it took a wire wheel on my dremel to remove it.
Posted: Mon Mar 14, 2011 10:19 pm
by Davidvaini
with every thing I paint, I make sure to prep prep prep.. I also apply many fine coats, as far as the brand, what brand did you use? link to a product page?
Posted: Tue Mar 15, 2011 6:41 pm
by kozak6
Leather dye is often used to stain other things. That would certainly be worth some experimentation.
Do you think spray on truck bed liner would be worth a try?
Do clear coats do anything significant for scratch resistance?
Posted: Sat Mar 26, 2011 10:54 am
by jimmy101
Someone might want to try Rit dye, or perhaps an aniline dye (used by wood workers), in acetone (finger nail polish). Acetone won't be as good a solvent as THF but you can get acetone a lot easier than THF. Acetone should penetrate PVC to some extent.
You could also break open something like a permanent marker (like a Sharpie) and take the ink up in acetone.