Page 1 of 1
Question about breech loading
Posted: Thu Jul 28, 2011 12:06 am
by jsefcik
Im a going to sleeve some pipe
Does the sleeve have to be air tight?
My opinion is yes, air would escape through the hole that is cut into the pipe and would escape around the sleeve
Your opinion helps!!!!
Posted: Thu Jul 28, 2011 12:30 am
by Gaderelguitarist
If it isn't airtight, a filler material would make it so. However, most cases of pipe being sleeved result in an airtight connection anyways. Some instances require a certain amount of labor with a hammer and such things to get the pipes to cooperate.
Posted: Thu Jul 28, 2011 2:52 am
by Crna Legija
yes imo for that reason id say don't use a sleeve but put threads on the end of your barrel
Posted: Thu Jul 28, 2011 10:03 am
by jsefcik
I found put that a shotgun casing fits well over the 1/2 inch copper tubing and air right
Posted: Fri Jul 29, 2011 9:18 am
by ramses
It doesn't have to be perfectly air tight, but it helps. Something a little tighter than the recommended fit for piston valves should be good.
Posted: Sat Jul 30, 2011 11:00 pm
by jsefcik
I used a 1 1/2 couplin that is sanded out enough that it slides over the sdr 21 1.5 inch barrel pipe perfectly
Posted: Fri Aug 05, 2011 6:17 am
by nathanhd123
Definitaly having it air tight helps. However I dont think ist the end of the worl if it leaks a bit.
Posted: Fri Aug 05, 2011 8:29 am
by jsefcik
My golf ball launcher which is sdr 1.5, i used a 1 1/2 coupler, i sanded the h** out of the inside it works fine, its really loose but the air is so quick , no issues at all,
and for my copper barrel which is 1/2 , i used 20 shotgun shells
oopps, didnt realized i posted this twice, just excuse this one