Page 1 of 1

Sealing the Chamber.

Unread postPosted: Wed Aug 17, 2011 4:23 pm
Author: Bias_P11
I had to put a screw into the PVC chamber, and I will seal it with epoxy. How should I go about doing this? should I sand the inside of the chamber hole as well and where should I dab the epoxy?

Unread postPosted: Wed Aug 17, 2011 4:40 pm
Author: mattyzip77
Chamber for what??? More info please!! Noone knows what you are talking about?

Unread postPosted: Wed Aug 17, 2011 4:44 pm
Author: Lockednloaded
I generally thread the screw in, remove it, cover it in epoxy, then re-screw it in and the epoxy just adheres to the gaps in the threads. If you tapped the hole properly and used a machine screw though, I suppose you could use teflon tape

Re: Sealing the Chamber.

Unread postPosted: Wed Aug 17, 2011 7:12 pm
Author: MrCrowley
Bias_P11 wrote:I had to put a screw into the PVC chamber, and I will seal it with epoxy. How should I go about doing this? should I sand the inside of the chamber hole as well and where should I dab the epoxy?

Did you drill through two layers of PVC?

Generally, I sand the area around the hole and then do what Lockednloaded suggested but by putting a dab of epoxy covering the hole and about 1/4" out from the hole and then thread the screw through the epoxy and in to the hole.

Unread postPosted: Wed Aug 17, 2011 9:49 pm
Author: Bias_P11
thanks imma try that tommorow