SpudFiles

can sch40 3/4 shoot anything else well besides 12g co2's?? because though can get kinda expencive.

68 cal. paint-balls fits well with my gun

ok, thanks a lot, do the balls need any wadding or anything??

my pipe is 3/4", the inner diameter is 0.69 inches, a paint ball is 68,
so wadding is not needed unless u want to have your gun to reach illegal speeds, as my friend had.<br>btw did the 12g co2 blow up?

idk, ive never actually tried shooting a full co2, cuz i would think it would explode sending shratnal everywhere, not to mention a waste of a perfectly good co2

he doesnt mean normal sch40 3/4" PVC will fit paintballs, 3/4" CPVC will though

oops, is the normal pvc smaller or bigger than cpvc?

normal pvc i do believe is bigger then cpvc

CPVC has a smaller ID than normal PVC, that's why 3/4" CPVC is great for Paintballs, and SCH 40 3/4" PVC is a too big and you need a lot of wadding.

does cpvc fit into normal pvc fittings?? or does the whole gun need to be made of cpvc??

then will a 12g co2 fit in my 3/4 cpvc? cuz i really want to try that

Ok, I don't belive a 12gram will fit into 3/4" CPVC. With me, they perfectelly fit into a SCH 40 3/4" barrel with little tape, so I think CPVC would end up being too small inside for a 12gram.

Yes you can connect CPVC to normal PVC, they have the same OD's (Outside Diamaters). However it is reccomended that you don't just glue them directelly together without using cement that is made for both PVC and CPVC. Some people say it's best to just use some threaded fittings so the CPVC barrel can just thread onto the PVC portion. This is becasue CPVC and PVC have a different chemical makeup, and bond together differentelly.

ok thanks a lot, i'll jsut do that