Page 2 of 2

Unread postPosted: Sun Feb 25, 2007 1:04 am
Author: pyromanic13
trae08 wrote:i just dont want nothing on the out side of the robot. i even want to put the barrell inside.

i figure if the barrell is inside and the warp feed is laying down it wont have to lift the weight of the bearings going up to the barrell it ould just have to push them side ways to the barrell


check out the Q-loader..

Unread postPosted: Mon Feb 26, 2007 12:30 am
Author: trae08
do you have one? id like to see some pics of the inside and how it works.. i know it works off spribgs but id like to see a diagram which i cant find on google

Unread postPosted: Mon Feb 26, 2007 12:56 am
Author: SEFishy
the spring is wound in a circular pattern. balls of course are pushed out of the "pod" as the spring unwinds. To bad its pricy

and doesnt hold enough balls but i gues were not shooing a paintgun here

Unread postPosted: Mon Feb 26, 2007 12:46 pm
Author: trae08
yea it seems pretty sweet its not as pricey as the warp feed and i culd get the 500 ball setup.


i been watchin videos and its pretty fast to.

Unread postPosted: Mon Feb 26, 2007 2:00 pm
Author: SEFishy
its just about the fastest you can buy and probley a better choice then teh warp feed. but not as "cool" i think lol

Unread postPosted: Mon Feb 26, 2007 10:47 pm
Author: trae08